Daily maintenance of metal shredder
The metal shredder is composed of a tool, a main shaft, a bearing, a reducer, a motor and a chassis. The bearing is fixed on the main shaft and is driven by the motor to make the main shaft rotate to shred the scrap metal. The bearing is used frequently. If you do not pay attention to maintenance and maintenance , it will cause damage to the bearing and affect the work of the equipment. Let's introduce how to maintain the metal shredder.
1. Regularly add lubricating oil to the bearing to ensure that it is clean and to avoid high temperature damage to the bearing;
2. Before and after get off work, check whether the bearing is damaged, and if there is a fault, it should be stopped immediately for repair;
3. The bearing is cleaned regularly, divided into rough cleaning and fine cleaning, and a metal grid is placed at the bottom of the container; during rough cleaning, use a brush in the oil to remove grease or adhesive; during fine cleaning, care must be taken. Bearings are carried out slowly in oil;
4. After cleaning the bearing of the shredder, apply butter on the bearing of the shredder and seal it well;
5. When the bearing is disassembled and inspected, a record should be made. In addition, the amount of remaining lubricating oil should be confirmed, and then the bearing should be cleaned;
6. If the equipment is found to be noisy or noisy during the work, it should be stopped for maintenance to see if the bearing is damaged.
The bearing is an important part of the metal shredder. Once damaged, it will not work. Moreover, the bearing on the shredder is relatively large, expensive, and inconvenient to assemble. Daily maintenance should be done to ensure that it can be produced for a long time without failure. .
The service life of the metal shredder is derived from the quality of the equipment, operating procedures and maintenance, especially the safe and correct operation can improve the performance of the equipment and reduce the occurrence of failures. Its impact is very large. In order to improve the operator's skills, Xiaobian Let's introduce the safe and correct operation rules and precautions of metal shredders.
1. The operator should wear a safety helmet and work clothes and other labor protection articles before the equipment is used;
2. The operator should abide by the safety management rules and regulations of the company and the workshop, and fully perform the safety work of his post;
3. The operator needs to be trained and can go to work after passing the assessment;
4. Before operation, the mechanical part, electrical part and operating environment of the equipment should be carefully checked to ensure that there is no abnormality before starting the equipment for operation;
Recommend products
CONTACT US:
If you have any requirement or suggestion, please fill in the form and send to us, thanks!E-mail:sunymachine@gmail.com | Whatsapp:+8613674945231
