Instructions for the use of scrap wire stripping machine
Scrap wire stripping machine is also known as: single-knife peeling machine for rolling, double-pass peeling machine for electronic wire, it can improve the recycling efficiency of scrap wire stripping. In our daily life, there are a lot of waste wires and cables. These waste wires often contain a large amount of copper wires. Many people use wire strippers to recover the copper inside after recycling waste wires and cables.
The working principle of the waste wire stripping machine: Before starting to separate and recycle the surface layer of the waste cable and the inner core, the street of the cable wire should be cut off to ensure the long-term durability of the blade, and then start feeding, the cable surface layer will pass through the blade on the machine It is cut by the surface layer, and then the cut waste cable is sent to the roller by the conveyor belt. Through the strong extrusion force of the roller, the inner core and the surface layer begin to separate, and then the personnel begin to say that the surface layer and the inner core are sorted and tied together, this is The complete working principle of the waste cable stripping machine.
Suitable for all kinds of wires:Cable processing range: 1-120mm.
Cable Stripping Machine is mainly used to recover a variety of wire and cable. Like electronic wire,cingle core wire ,double core,car wires, rubber insulated lead sheathed and armored cable.
Precautions during use:
1. Note that the blade should not be too sharp, so as not to damage the inner core, and pay attention to setting the position of the blade according to different cables.
2. Pay attention to check whether the position is wrong when feeding.
In addition, it should be noted that although this kind of wire stripping machine is relatively simple, just put the waste cable into the wire inlet, the machine will separate the inner core from the surface layer through the strong extrusion force of the roller, and the personnel can sort it out. However, before starting processing, it is necessary to cut the cable with a blade, otherwise it will cause an inseparable site. The pressure of the spring should be adjusted according to the processing cable, and the cable will not pass through if it is too tight.
Recommend products
CONTACT US:
If you have any requirement or suggestion, please fill in the form and send to us, thanks!E-mail:sunymachine@gmail.com | Whatsapp:+8613674945231
